Kyocera FS-6525MFP Service Manual page 181

Code Contents
8360 Slide motor problem (docu-
ment finisher)
The slide sensor does not turn
on/off within specified time of
the slide motor turning on.
8460 EEPROM problem (docu-
ment finisher)
Reading from or writing to
EEPROM cannot be per-
formed.
8800 Document finisher commu-
nication error
A communication error is
detected 10 times in succes-
sion.
8830 Bridge communication
error (document finisher)
A communication error is
detected 10 times in succes-
sion.
Causes
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Slide motor and DF main PWB (CN14)
Slide sensor and DF main PWB (CN22)
Defective slide Replace the slide sensor.
sensor.
Defective slide Replace the slide motor.
motor.
Defective DF main Replace the DF main PWB and check for
PWB. correct operation.
Defective Replace the DF main PWB and check for
EEPROM or DF correct operation.
main PWB.
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Engine PWB (YC19) and DF relay PWB
(YC2)
DF relay PWB (YC3) and DF main PWB
(CN1)
Defective DF main Replace the DF main PWB and check for
PWB. correct operation.
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-35).
Defective connec- Reinsert the connector. Also check for conti-
tor cable or poor nuity within the connector cable. If none,
contact in the con- replace the cable.
nector. Engine PWB (YC19) and DF relay PWB
(YC2)
DF relay PWB (YC4) and bridge PWB (YC5)
Defective bridge Replace the bridge PWB and check for cor-
PWB. rect operation.
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-35).
1-4-19
Check procedures/
corrective measures
2MW/2MX