The Remote Unit; Figure 3- Connect The Extended Components To The Remote Unit - NTI XTENDEX Series ST-C5VRS-600 Installation And Operation Manual

The Remote Unit

1. Position the Remote Unit such that the CAT5 cable, the monitor cable, RS232 cable, and the AC adapter
power connector can each reach the Remote Unit comfortably.
2. Connect the monitor cable to the female 15HD video connector on the Remote Unit.
3. Connect the RS232 cable from a touchscreen monitor (see Fig. 3) to the male 9D connector
on the Remote Unit.
S T - C 5 V R S - 6 0 0 R e m o t e U n i t
F r o n t V i e w
R e m o t e U n i t
N T I
N e t w o r k T e c h n o l o g i e s I n c
9 D M a l e
R S 2 3 2 C o n n e c t o r

Figure 3- Connect the Extended Components to the Remote Unit

4. Make sure the CAT5 cable has been installed in accordance with the "Preparation for Installation"
instructions on page 3. Connect the CAT5 cable to the "Cat 5" port on the Remote Unit. (See Fig. 3.)
When properly inserted the CAT5 cable end should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other end of the extension cable to the RJ45
wall outlet.
!
WARNING: Never connect the ST-C5VRS-600 Extender to an ethernet card, ethernet router,
hub or switch or other ethernet RJ45 connector of an ethernet device. Damage to devices connected
to the ethernet may result.
o f
-
+
R
X T E N D E X
C A T 5 C a b l e t o
L o c a l U n i t
( F r o n t a n d R e a r V i e w )
R e a r V i e w o f R e m o t e U n i t
V G A
M u l t i - S c a n
T o u c h - s c r e e n
M o n i t o r
R e m o t e U s e r ' s M o n i t o r
6
1 5 H D F e m a l e
V i d e o C o n n e c t o r