Using Rtk Corrections - Raven Cruizer II Operation Manual

Using RTK Corrections

This section contains information on the available settings and configuration
of the internal dual frequency receiver featured in the Cruizer II RTK console
(P/N 063-0173-327). Refer to the following sections to configure the receiver
to utilize a real time kinematic (RTK) differential correction source, such as a
Slingshot Field Hub™, during field operations.
RTK Differential Source Setup
To set up the Cruizer II RTK console to receive RTK corrections from the
Cruizer II Home screen:
1. Touch Tools Menu
The Differential screen will be
displayed.
2. Select the 'RTK' option from
the source list along the left
side of the screen. The RTK
correction settings will be
displayed on the Differential
screen.
Note: The default differential
settings noted in the
following steps are
recommended if a
Slingshot Field Hub will
be used as the source for
differential corrections.
If RTK is not available in the source list, the internal receiver is not
capable of receiving a dual frequency correction signal.
3. Touch the 'Baud Rate' option and select the baud rate at which corrections
are transmitted from the RTK correction source. The default baud rate
setting is 115200.
4. Touch the Format option and select the format of the correction messages
sent from the RTK correction source. The default setting is RTCMV3.
5. Touch the Network option and select the network from which the RTK
corrections will be delivered. The default setting is 'Disabled' and is
recommended when connected with a Slingshot Field Hub.
6. Touch the Elevation option to adjust the elevation mask, or cutoff, value.
The default value for this setting is zero.
Note: Review the
GPS status icons displayed by the Cruizer II console.
2 6
GPS
GPS Status Icon
Differential
section on page 6 for information on the
.