Raven Cruizer II Operation Manual page 23

Sections Setup
The Section configuration uses the programmed antenna Offset values to
determine the relative location of each section with respect to the GPS
antenna. If the GPS antenna is moved, or if the offset values are modified,
verify that the section settings are correct before starting or resuming a field
operation. To set up sections for automatic section control:
1. From the Home
Tools Menu
Note: The Sections icon is only available in the Tools Menu if the Cruizer II
detects the AccuBoom node on the CANbus. If the appropriate
hardware has been installed, review the
section on page 30 to troubleshoot the node.
2. Touch the Settings Lock
use the No. of Sections selector or
Keypad
available sections (maximum 10)
on the implement. The Cruizer II
will automatically divide the
configured swath width by the
selected number of sections.
3. The list of configured sections is
displayed below the No. of
Sections slider. This list is
automatically updated if the
number of sections is adjusted. Use the up or down arrows to display
additional section settings if necessary.
Note: Section 1 corresponds to the left most section (as observed from the
operator cabin facing forward) in a standard boom configuration.
4. Touch any of the displayed section values (width, left/right or fore/aft) and
use the displayed keypad to enter a new value for the section setting.
Note: The configured swath width and total AccuBoom section width is
displayed in the lower, left corner of the Sections screen.
Touch the displayed AccuBoom width to enter a different total section
width. The Cruizer II will automatically divide the new width by the
selected number of sections. In a standard boom configuration, the
Swath and total AccuBoom section widths should be equal values.
5. Touch Center Sections
align configured sections end-to-end centered on the swath midpoint.
6. Touch the Accept
the Tools Menu.
Screen, select
Vehicle
to set the number of
icon to save the displayed settings and return to
Sections
CANbus Troubleshooting
and
Number of
Sections Slider
at the bottom of the screen to automatically
.
Settings Lock
Center Sections
2 1