Ending A Job; Powering Down The Cruizer Ii; Standby Mode - Raven Cruizer II Operation Manual

Marker Information
Touch the base of the marker and select the Information
the Edit Marker screen. This screen displays the marker name and the current
distance to the marker.
Touch the name field and use the on-screen keyboard to rename the marker.
Marker names should not begin or end with a space.
Delete Markers
To delete a marker, touch the base of the marker and select Delete
The marker will be removed.

Ending a Job

Use the following steps to end a Job:
1. Touch Menu
2. To save a report for the job, see the

Powering Down the Cruizer II

Use the following steps to power down and shut off the Cruizer II. From the
Home Screen:
1. Touch the End Job
2. Select Shut Down
3. Select the Accept

Standby Mode

Use the standby mode to conserve power for short periods such as breaks or
refilling tanks. This mode allows the operator to quickly resume a job in
progress without shutting down the Cruizer II console.
Note: The Cruizer II will automatically enter the standby mode after two hours
of inactivity without a job in progress. Review the recommendations in
the Care and Maintenance
Cruizer II console in a vehicle for extended periods.
Momentarily press the power button to send the console into standby mode.
Press the power button again to toggle the display back on and return the
Cruizer II to a normal operation mode.
Note: Cruizer II display will resume in approximately 15 seconds. Depending
upon GPS coverage, it may take several seconds to reinitialize GPS
reception. Verify that the GPS status indicator displays DGPS O.K.
before resuming field operations.
1 6
Home Screen
Coverage Maps
icon if a job is in progress.
and Accept
icon again to power down the Cruizer II.
section on page 3 regarding leaving the
End Job
section on page 24.
.
icon to display
.
.