KIP 5000 User Manual page 4

WARNING
Properly Ground the product to a ground source. Failure to do so may
result in electrical shock or damage to the equipment.
1. The Power source must be as follows:
120V plus or minus 10%, 16A and 50/60Hz
2. Use a circuit with a dedicated breaker.
3. Install the product as close to the wall outlet as possible.
4. If you wish to move the printer, please contact your service personnel.
1. Do not remove screws or open covers unless specifically instructed to
do so in this User's Manual. Failure to follow this warning may result in
electric shock, or burns.
2. Do not disassemble or tamper with the printer.
Doing so may result in a fire or electric shock.
1. Do not plug in the printer into a multi-wire connector with other
equipment. Doing so may result in fire do to the outlet overheating.
2. Do not damage the Power Cord by stepping on or placing heavy items
on it. If the Power Cord is damaged, it may cause a fire or electric shock.
REPLACE THE CORD IF DAMAGED!
Do not place liquids onto the system ie. a flower vase, a flowerpot, coffie
cup or any water-filled item on the. Spilt water may cause fire or electric
shock.
If the product generates an abnormal smell or noise, turn it off and unplug it
form the wall. Contact your certified service technician.
Do not throw the toner or toner cartridge into a fire or other sources of heat,
as it can explode.
(3)