Astro Machine AstroJet M1 Operator's Manual page 46

SECTION 4
MAINTENANCE
2. Make sure the Printhead Cover is fully opened to retract the ink lines. Remove the Printhead
Cartridge by tilting it toward the ink lines [3], then carefully lift it out of the Printhead
Compartment.
3. Carefully pack the Cartridge using the original packaging.
Remove the Service Station
TURN PRINTER POWER OFF.
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS THE POWER BUTTON ON THE CONTROL PANEL.
2. WAIT FOR THE PRINTER TO STOP PROCESSING.
3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.
1. Open the Front Cover (hinged at bottom). Remove
the Exit Roller Cover by removing the four (4) screws.
Open the Top Cover.
2. Slide the Service Station out of the Service Station
port. NOTE: Do not pull Station all the way out until
you disconnect the Ribbon Cable.
42
CAUTION