Astro Machine AstroJet M1 Operator's Manual page 40

SECTION 4
MAINTENANCE
6. [1] Plug the Ribbon Connector (blue side up) into
the space under the Latch.
[2] Close the Latch.
7. [1] Slide the Service Station into the Service Station port until it touches the bar.
[2] Look down through the Top Cover to make sure Service Station is aligned with the bar.
IMPORTANT! Service Station must be perfectly aligned with bar to prevent misalignment
and operating problems.
8. GENTLY push the Service Station while
turning the large Gear on right side of Print
Engine clockwise. Gear should engage
gear on Service Station Roller and pull it
in. Once the Service Station starts moving,
stop turning the gear. Powering up the unit
will pull the Service Station the rest of the
way in. NOTE: Make sure the wick
hanging below the Service Station is inside
the plastic trough inside the Ink Tank
Station to prevent ink seepage.
9. Replace the Exit Roller Door and Close
the Front Cover.
36