Setting Up The Feed - Astro Machine AstroJet M1 Operator's Manual

SECTION 2
INSTALLING THE PRINTER

Setting up the Feed

The AstroJet M1 Printer is equipped with four sheet separators, two side guides and a rear media guide.
The sheet separators are adjusted individually as follows:
1. Move the left-hand side guide into position. This guide has two positions. The position closest to
the side frame is for 9.5" media and the position closest to the center of the printer is for printing
8.5" wide media edge to edge.
2. Loosen the locking screws located behind
the sheet separators and raise the paper
separators, then tighten the locking screws
to hold the separators in the up position.
3. Place a single piece of the media to be run
under the separators. Always place the
media against the left-hand paper guide.
Loosen the separator locking screw and
allow the paper separator to settle onto the
media. Then tighten the locking screw.
Repeat for each paper separator.
18