Install The Service Station - Astro Machine AstroJet M1 Operator's Manual

SECTION 2
INSTALLING THE PRINTER

Install the Service Station

The Service Station cleans the Printhead Cartridge of excess ink and debris, keeps the Printhead hydrated
and protected when not in use, captures ink used to keep nozzles clear, and acts as a base to support media
during printing. It fits in the port immediately above the Ink Tank Station.
TURN PRINTER OFF:
 PRESS THE POWER BUTTON THE CONTROL PANEL
 WAIT FOR THE PRINTER TO STOP PROCESSING
 PRESS THE MAIN POWER SWITCH ON THE REAR PANEL
1. Open the Front Cover (hinged at bottom). Remove the Exit Roller Cover by removing the four (4)
screws. Open the Top Cover.
2. Carefully unwrap the Service Station. NOTE:
Loose parts may fall out. Keep wiper roller side
facing up when removing packaging.
CAUTION
Make sure latches on the Wiper
Roller are fully latched before
installing the Service Station.
3. Slide the Latch open on the Service Station
Circuit Board.
10