Astro Machine AstroJet M1 Operator's Manual page 23

4. Adjust the right hand side guide so that it is about
1/32-inch from the sides of the media. Tighten the
locking knob on the side guide. Place a stack of
media in the machine. Press and hold the Paper key
to feed one piece through the separator. NOTE: To
prevent misfeeds and tearing, keep the right
hand side guide at least 1/8" from the side frame.
5. Adjust the rear support guide by using the knob
to slide the guide right and left. If you experience
feeding problems, slide the rear support guide
right or left keep the media aligned with the
media guides.
6. Adjust the rear media guide by loosening the
locking screw and moving the guide to raise the
media approximately 2" above the feed table for
paper and about 1/2" for envelopes.
NOTE: The amount of media that can be stacked
on the printer is determined by the weight of the
material. The feeder may not feed larger and
heavier media when the stack is full. If this is the
case, reduce the amount of media in the stack until
the feeder functions properly.
SECTION 2
INSTALLING THE PRINTER
19