Astro Machine AstroJet M1 Operator's Manual page 20

SECTION 2
INSTALLING THE PRINTER
4. Wet the Printhead Surface. This
ensures that the Printhead will prime
correctly. Open the Top Cover. Release
and lift up the two latches (one on each
side of the Printhead Assembly) at the
same time to raise the Printhead
Assembly. Moisten the Printhead
nozzles using distilled water and a
wet, lint-free cloth. Close and relatch
the Printhead Assembly.
OPERATE AND HOLD ONTO BOTH LATCHES WHEN OPENING AND
CLOSING THE PRINTHEAD ASSEMBLY TO PREVENT DAMAGE.
DO NOT ALLOW THE ASSEMBLY DROP BY ITSELF TO CLOSE LATCHES.
TO PREVENT DAMAGE TO THE INK LINES, A STOP LIMITS RAISING THE
ASSEMBLY MORE THAN 60°.
5. Close the Printhead Cover [6]. The Printer
will run a start-up routine and priming ink
into the Printhead. This may take a few
minutes. Make sure that ink is flowing
through the hoses.
16
CAUTION