Astro Machine AstroJet M1 Operator's Manual page 15

4. [1] Plug the ribbon connector (blue side up) into the
space under the Latch.
[2] Close the Latch.
5. [1] Slide the Service Station into the Service Station port until it touches the bar.
[2] Look down through the Top Cover to make sure Service Station is aligned with the bar.
IMPORTANT! Service Station must be perfectly aligned with bar to prevent misalignment.
6. GENTLY push the Service Station while
turning the large Gear on right side of Print
Engine clockwise. Gear should engage
gear on Service Station and pull it in. Once
the Service Station starts moving, stop
turning the Gear. Powering up the unit will
pull the Service Station the rest of the way
in. NOTE: Make sure the wick hanging
below the Service Station is inside the
plastic trough inside the Ink Tank Station
to prevent ink seepage.
7. Turn power back on by pressing the Main
Power Switch, then pressing the Power Button on the Control Panel.
8. Gently close the Top Cover, replace the Exit Roller Door and close the Front Cover.
SECTION 2
INSTALLING THE PRINTER
11