Print Engine - Astro Machine AstroJet M1 Operator's Manual

SECTION 4
MAINTENANCE

Print Engine

Areas in the Print Engine can become glazed with a buildup of dust, paper lint and accumulated ink and
have to be cleaned regularly. Open the Top Cover and release the two latches on the Printhead Assembly.
NOTE: Be careful around ink tray and capping station in the Print Engine area as accumulated ink may
splash onto other parts of the printer. Take care not to damage the PC Boards or electrical wiring.
[A] Grit Rollers: Clean as needed
with distilled water on a damp lint-
free cloth. DO NOT use anything
other than distilled water to clean the
rollers.
[B] Media Sensors: Paper lint and
dust may build up on the Media
Sensors. Use a can of compressed air
or a damp (not wet) q-tip to gently
swab the sensors. Take care not to drip
water into the circuit boards.
Remember to wipe the clear panel
over the Sensor Receiver in the upper
Printhead Assembly (see inset).
[C] Capping Station Seal and Squeegee. Clean as needed with
distilled water on a damp, lint-free cloth. Be careful not to splash or
drip ink on other parts of the printer.
[D] Printing Platen. Wipe with distilled water on a damp, lint-free cloth.
40