Exerpeutic Elliptical 1302 Owner's Manual page 14

7
(28) Cap S13, 2 PCS
13L LEFT
CORRECT
INCORRECT
INCORRECT
Right Crank
Left Bolt
ASSEMBLY
Insert a 1/2" Bolt for left U Shape Bracket (13L)
and put the Wave Washer (15) through the left U
Shape Bracket (20). Put a Spring Washer (17)
on the bolt, then pass it through the left Crank
(75), and secure the bolt with a Left Nylon Nut
(14L). Install one S13 Cap (28) onto the
M8x45Bolt (23). Repeat this procedure for the
right side assembly.
13R RIGHT
Please be noted the very important point:
Before you put a Left Nylon Nut (14L) and a
Spring Washer (17) on the 1/2" Bolt for left U
Shape Bracket (13L), make sure the 1/2" Bolt for
left U Shape Bracket (13L) had been screwed to
the end position with the left U Shape Bracket
(20).
In order to install the hinge bolt properly, keep it
perfectly straight when the bolt goes through the
pedal tubing and the crankshaft. If the hinge
bolt is connected to the crankshaft at an angle,
damage to both the hinge bolt and the
crankshaft may occur.
Right Bolt
Important:
Please make sure the right bolt matches up
with the right crank and the left bolt matches
up with the left crank.
If reversed the cranks may become
damaged or stripped.
Left Crank
(13L/R) Bolt for left/right U
Shape Bracket
(14L/R) Left/Right Nylon Nut
(15) Wave Washer
(17) Spring Washer
13
2 PCS
2 PCS
2 PCS
2 PCS