Table of Contents
Advertisement
This fireplace system has been tested and listed in
accordance with
Underwriters Laboratories Inc. for installation and operation
in the United States as described in this manual.
This fireplace has been tested and listed for use with the
optional components listed on page 5. These optional
components may be purchased separately and installed at
a later date.
B. DESCRIPTION OF THE FIREPLACE SYSTEM
Fireplace/Integral Grate/Outside Combustion Air
System/Refractory
Chimney Termination Cap
Chimney System
Hearth Extension
Glass Doors
Chimney Air Kit
Note:
Illustrations used throughout these instructions
reflect “typical installations” and are for design purposes
only. Actual installation may vary slightly due to individual
design preferences. However, minimum and maximum
clearances must be maintained at all times.
The illustrations and diagrams used throughout these
installations instructions are not drawn to scale.
4
A. LISTINGS AND CODE APPROVALS
standards, and has been listed by
35144 Rev E
ICON I100 INSTALLATION INSTRUCTIONS
Check with your local building code agency prior to installing
this fireplace to ensure compliance with local codes,
including the need for permits and follow-up inspections. If
you need assistance during installation, please contact your
local dealer or the Heatilator Technical Services
Department, Hearth & Home Technologies Inc., 1915 W.
Saunders St., Mt. Pleasant, Iowa 52641 (1-800-927-6841).
Heatilator® is a registered trademark of Hearth & Home
Technologies Inc., Division, HON INDUSTRIES.
WARNING!
Figure 1 - Typical Fireplace System
12/03
Hide quick links:
Advertisement
Table of Contents
