Table of Contents
Advertisement
BIOS
IR Transmission delay: This default is Enabled (when UART Mode Select is not
set to Normal).
Options: Enabled and Disabled
Onboard Parallel port: This field allows the user to configure the LPT port.
The default is 378H / IRQ7.
378H: Enable Onboard LPT port and address is 378H and IRQ7.
278H: Enable Onboard LPT port and address is 278H and IRQ5.
3BCH: Enable Onboard LPT port and address is 3BCH and IRQ7.
Disabled: Disable Onboard Winbond Chip's LPT port.
Parallel Port Mode: This field allows the user to select the parallel port mode.
The default is ECP+EPP.
Normal: Standard mode. IBM PC/AT Compatible bidirectional parallel port.
EPP:
Enhanced Parallel Port mode.
ECP:
Extended Capabilities Port mode.
EPP+ECP: ECP Mode & EPP Mode.
ECP Mode USE DMA: This field allows the user to select DMA1 or DMA3 for
the ECP mode. The default is DMA3.
DMA1:
This field selects the routing of DMA1 for the ECP mode.
DMA3:
This field selects the routing of DMA3 for the ECP mode.
ECP Mode Select: This field sets what EPP mode variation to use.
EPP1.9: Sets EPP1.9
EPP1.7: Sets EPP1.7
Page 4-20
EP-BX6
Advertisement
Table of Contents
