EPOX EP-BX6 User Manual page 48

BIOS
The "LOAD SETUP DEFAULTS" function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.
IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
USB Keyboard Support
Init Display First
POWER ON Function
KB Power ON Password
Hot Key Power ON
Onboard FDC Controller
Onboard Serial Port 1
Note: If you do not use the onboard IDE connectors, then you will need
to set Onboard Primary PCI IDE: Disabled and Onboard second-
ary PCI IDE : Disabled. The onboard PCI IDE cable should be
equal to or less than 18 inches (45cm).
IDE HDD Block Mode: IDE Block Mode allows the controller to access blocks
of sectors rather than a single sector at a time. The default is Enabled.
Enabled: Enabled IDE HDD Block Mode. Provides higher HDD transfer
rates.
Disabled: Disabled IDE HDD Block Mode.
Page 4-16
ROM PCI/ISA BIOS(2A69KPAI)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
: Enabled Onboard Serial Port 2
: Auto UART Mode Select
: Auto UART2 Duplex Mode
: Auto RxD, TxD Active
: Auto IR Transmission delay
: Auto Onboard Parallel Port
: Auto Parallel Port Mode
: Auto ECP Mode Use DMA
: Auto EPP Mode Select
: Enabled PWRON After PWR-Fail
: Enabled
: Disabled
: PCI Slot
: Hot Key
Esc : Quit
: Enter
F1 : Help
: Ctrl-F1
F5 : Old Values
: Enabled
F7 : Load Setup Defaults
: 3F8/IRQ4
Figure 7: Integrated Peripherals
EP-BX6
: Disabled
: Normal
: Half
: Hi, Lo
: Enabled
: 378H/IRQ7
: ECC+ECP
: 3
: EPP1.7
: Off
: Select Item
PU/PD/+/- : Modify
(Shift) F2 : Color