EPOX EP-BX6 User Manual page 51

EP-BX6
Hot Key Power On: Use this option with the above "Power On Function" to set a
combination of keys that can be used to power the system on. The default is Ctrl-F1.
Options: Ctrl-F1, Ctrl-F2, Ctrl-F3, Ctrl-F4, Ctrl-F5, Ctrl-F6, Ctrl-F7, Ctrl-
F8, Ctrl-F9, Ctrl-F10, Ctrl-F11, and Ctrl-F12.
Onboard FDC Controller: This controls the state of the onboard floppy
controller. The default value is Enabled.
Enabled: Enable the Onboard Winbond Chips's floppy drive interface
controller.
Disabled: Disable the Onboard Winbond Chip's floppy drive interface
controller.
Onboard Serial Port 1: This field allows the user to configure the 1st serial
port. The default is 3F8/IRQ4.
AUTO: Enable Onboard Serial port 1 and address is Auto adjusted
COM1: Enable Onboard Serial port 1 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 1 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 1 and address is 3E8H/IRQ4.
COM4: Enable Onboard Serial port 1 and address is 2E8H/IRQ3.
Disabled: Disable Onboard SMC CHIP's Serial port 1.
Onboard Serial Port 2: This field allows the user to configure the 2nd serial
port. The default is Disabled.
AUTO: Enable Onboard Serial port 2 and address is Auto adjusted
COM1: Enable Onboard Serial port 2 and address is 3F8H/IRQ4.
COM2: Enable Onboard Serial port 2 and address is 2F8H/IRQ3.
COM3: Enable Onboard Serial port 2 and address is 3E8H/IRQ4.
COM4: Enable Onboard Serial port 2 and address is 2E8H/IRQ3.
Disabled: Disable Onboard SMC CHIP's Serial port 2.
UART Mode Select: The mode of the IR Controller. The default is Normal.
RxD, TxD Active: This field configures the receive and transmit signals gener-
ated from the IR port. The default is Hi Lo (when UART Mode Select is not set to
Normal).
Options: Hi Hi, Hi Lo, Lo Hi, and Lo Lo.
BIOS
Page 4-19