Configuring The Analog/Digital Converter; Purpose; Features; Note On Settings - Sartorius CW3P Service Manual

Configuring the Analog/Digital Converter

Purpose

To adapt the Combics for use with any commercially
available strain-gauge load cell or analog Sartorius CAPP,
CAPS, IU or IF weighing platform by selecting or entering
parameters in the Setup program. Access is restricted by a
special password (service password).

Features

With the menu access switch open, you can configure
most of the parameters affecting the following
specifications:
– Toggle between „Standard" and
„Verifiable" („Legal for trade") mode
(configuration for use in legal
metrology)
– Verification scale interval e
– Scale interval d
– Minimum load
– Maximum load
– Maximum load for a given range
– Verification scale interval e for a given range
16
– Available weight units
– Weight unit for calibration/adjustment
These parameters are not affected when you restore the
factory settings (menu item: Factory settings:
all parameters all parameters
all parameters on the highest level of the Setup menu. all parameters all parameters
Parameters not listed above are not affected by your choice
of Standard or Trade configuration; the same
restrictions apply as for Sartorius weighing instruments that
do not offer a choice between the two configurations.

Note on Settings

ADC configuration ADC configuration
The ADC configuration ADC configuration ADC configuration menu is opened from the Setup
Device parameters Device parameters
menu, under Device parameters Device parameters (weighing platform 1: Device parameters
WP1 WP1
WP1 WP1 WP1; weighingplatform 2: COM1
transfer protocol).
The menu is shown on page 19.
The A/D converter can be configured only in the Service
mode and only with the menu access switch open.
Factory settings: Factory settings:
Factory settings: Factory settings:
COM1 COM1 COM2 COM2
COM1 or COM2 COM1 COM2 COM2, withs uitable