Table of Contents
Advertisement
Figure 26. Opening pulley door.
Figure 27. Changing abrasive disc with table off.
Figure 28. Changing abrasive disc with table on.
Changing Abrasive Disc
To replace abrasive sanding disc:
1. Remove the working table assembly.
2. Remove the knob holding the pulley cover
door shut and open the door as shown in
Figure 26.
3. Remove the worn sanding disc and the new
sanding disc. Be sure to center the new sand-
ing disc over the cast iron disc before press-
ing it down as shown in Figure 27.
4. Another option allows you to leave the pul-
ley cover and working table attached. Peel
back half of the abrasive disc backing and
slip the covered portion behind the closed
pulley door. Stick the peeled back portion of
the abrasive disc to the top half of the sand-
ing wheel. Carefully rotate the disc 180°.
Peel back the second half of the abrasive
backing and stick the remaining portion to
the sanding disc as shown in Figure 28. Press
then entire disc on to ensure good adhesion.
-21-
Advertisement
Table of Contents
