Sanding Unit To Base
The Model W1676 comes with a prefabricated
welded steel stand that requires no assembly.
However, the sanding unit needs to be mounted
to the stand.
The W1676 represents a
heavy
pounds. Seek assistance
before beginning assem-
bly.
1. With the help of a friend, lift the main sand-
ing unit on top of the steel stand.
2. Align the four mounting holes in the stand
with the slots on the bottom corners of the
sanding unit as shown in Figure 9.
5
3. Using (4)
⁄
"-18 x
16
5
ers and
⁄
" nuts, fasten the sanding unit to
16
the stand.
Idler Roller
Install the idler roller by inserting its flat axle
ends into the slots on the ends of the adjust-
ments bar as shown in Figure 10.
NOTICE
Until the sanding belt is installed, along
with the idler guard, the idler roller can
fall off causing damage.
Sanding Disc
The sanding disc is installed onto the keyed
5
drive shaft using a
⁄
shown in Figure 11. For clearance purposes, we
have included a long shaft 4mm Allen
load
at
170
1
5
⁄
" hex bolts,
⁄
" wash-
2
16
3
"-18 x
⁄
" setscrew as
16
8
®
wrench.
Figure 9. Stand mounting holes.
Figure 10. Idler roller.
Figure 11. Installing sanding disk.
-14-