Electrical Section; Electrical Part - Elba DOMINO COOKING HOBS Instruction For The Use - Installation Advice

6
IMPORTANT: Install the appliances
following the manufacturer's
instructions.
Incorrect installation can cause
damage to people, animals or
things, for which the manufacturer
cannot be held responsible.

ELECTRICAL PART

The appliance must be connected to
the mains by a competent electrician
and according to the regulations in
force.
The appliance must be connected to
the mains checking first of all that the
voltage corresponds to the value given
on the rating plate and that the section
of the electrical cables can take the
load indicated on the rating plate.
Fit a standard plug which is suitable
for the power absorbed by the
appliance and in conformity with the
local rules in force.
The plug must be put into a socket
connected to the earth system in
compliance with safety rules.
For the United Kingdom:
As the colours of the wire of the supply
cable of this appliance may not
correspond with the colours which
identify the terminals of your plug,
proceed as follows:
– the yellow/green wire must be
connected to the plug terminal
marked with the letter E or with the
earth symbol or coloured green or
yellow/green;
– the blue wire must be connected to
the terminal marked with the letter
N or coloured black;
– the brown wire must be connected
to the terminal marked with the letter
L or coloured red;
22

ELECTRICAL SECTION

The connection can be made directly
to the mains by putting an all-pole
switch
between the contacts of 3 mm
between the appliance and the mains.
The supply cable must not touch hot
parts and must be so positioned that
it does not exceed the temperature of
75°C at any point.
When the appliance is installed the
switch or socket must always be
accessible.
The appliance must have its own
supply; any other appliances installed
near it must be supplied separately.
N.B. For connection to the mains
do not use adapters reductions or
shunts because these can cause
overheating or burning.
If the installation requires modifications to
the domestic electrical system or if the
socket and the appliance plug are not
compatible, contact a professional
electrician.
He must, in particular, also make sure
that the section of the socket cables is
suitable for the power absorbed by the
appliance.
The appliance must be connected to
the earth.
The manufacturer declines all
responsibility for any problem
caused by failure to observe this
instruction.
with minimum opening