Electrical Section - Elba P60 Series Instruction For The Use - Installation Advice

6
IMPORTANT: Installation must be
carried out according to the man-
ufacturer's instructions. Incorrect
installation may cause harm and
damage to people, animals or prop-
erty, for which the manufacturer
accepts no responsibility.
Before carrying out any work on the
electrical section of the appliance,
it must be disconnected from the
mains.
Connection to a good earth wiring
system is absolutely essential.
The manufacturer accepts no
responsibility for any inconvenience
caused by failure to comply with
this rule.
DETAILS
✓ Connection to the electric power sup-
ply must be carried out by a qualified
technician and following the appropri-
ate safety regulations;
✓ Before carrying out the connection
to the power supply, the voltage rat-
ing of the appliance (stamped on the
appliance identification plate) must be
checked for correspondence to the
available mains supply voltage, and
the mains electric wiring should be
capable of handling the hob's power
rating (also indicated on the identifica-
tion plate);
✓ The power point must be connected
to a suitable earth wiring, in conform-
ity to current safety regulations.
✓ The hob is supplied without a power
supply plug and therefore if you are
not connecting directly to the mains, a
standardized plug suitable for the load
must be fitted.
32

ELECTRICAL SECTION

✓ It is possible to connect the appli-
ance directly to the mains supply by
means of a heavy duty switch with 3
mm minimum distance between the
contacts.
✓ The power supply cord must not
touch against any hot surfaces and
must be placed so that its tempera-
ture does not exceed 75°C at any
point along its length.
✓ After having installed the appliance,
the power switch or power plug must
always be in a accessible position.
N.B. For connections to the mains
power supply, never use adapters,
reductions or multiple power points
as these may overheat and catch fire.
In the event that installation should
require modifications to the mains sup-
ply wiring system or if the power plug
is not suitable for the type of power
point available, it is recommended that
a qualified technician be called to carry
out substitution.
The technician will also have to verify
that the cross-section of the electric
cables on the power point match the
appliance's power rating.