Elba DOMINO COOKING HOBS Instruction For The Use - Installation Advice page 21

FASTENING THE APPLIANCES
Each appliance is supplied with a set of
tabs and screws to fasten it on units.
– Cut the unit (as shown in the figure
on the previous page).
– Stretch gasket "D" over the edge of
the hole made being careful to overlay
the junction edges.
– Turn the appliance over and put tabs
"A" into the mountings; only tighten
screws "B" a few turns.
Make sure that the tabs are mounted
correctly as shown in the figures at
the side. Turn the tabs so that the
appliance can be put into the hole.
– Put the cooktop into the hole cut into
the unit and position it correctly.
– Put tabs "A" into place, tooth "C" of
the tabs should go into the hole.
– Tighten screws "B" until the appliance
is completely secured.
– Using a sharp tool cut off the part of
gasket "D" which protrudes from the
cooktop.
A
Fig. 5.5
C
B
Fig. 5.6
A
A
A
D
A
21