Table of Contents
Advertisement
N O T E
N O T E
N O T E
N O T E
N O T E
The low voltage cable assembly is not
>
repairable due to it's construction. The
cable assembly must be replaced.
2. If the low voltage cable assembly has not been
tested, it should be tested. (Refer to "Low Voltage
Control Unit Test Assembly" manual.)
3. The low voltage cable assembly can be wiped
with a suitable solvent. DO NOT soak or submerge
the cable assembly in solvent.
4. Check the full length of cable for wear or breaks
in the cable sheathe. If any are found, the cable
assembly should be replaced.
Assembly
Assembly
Assembly
Assembly
Assembly
1. Connect the low voltage cable assembly to the
low voltage cable plug assembly of the handle.
C A U T I O N
C A U T I O N
C A U T I O N
C A U T I O N
C A U T I O N
! ! ! ! !
Do NOT overtighten the low voltage
>
cable connection to the handgun as damage
to plastic parts may occur.
2. Route the low voltage cable assembly back to
the low voltage control unit and attach the cable
assembly into the air hose/fluid hose bundle.
3. Connect the low voltage cable assembly to the
low voltage control unit.
AH-94-04.7
REA-90 and 90L Spray Applicators - Maintenance
FLUID TUBE
FLUID TUBE
FLUID TUBE
FLUID TUBE
FLUID TUBE
(SOL
(SOL
(SOL
(SOLVENT
(SOL
APPLICA
APPLICAT T T T T ORS)
APPLICA
APPLICA
APPLICA
(Refer to Figure 22)
(Refer to Figure 22)
(Refer to Figure 22)
(Refer to Figure 22)
(Refer to Figure 22)
Removal
Removal
Removal
Removal
Removal
1. Remove the applicator from service. (Refer to
"To Remove the Applicator from the Work Site".)
2. At the fluid tube bracket, unscrew the plastic
nut from the fitting using a 3/4-inch open end
wrench and slide it up the fluid tube.
3. Unscrew the fluid tube connector from the
barrel and slide it down the fluid tube.
4. Pull the fluid tube out of the fitting at the fluid tube
bracket.
Item #
Item #
Item #
Item #
Item #
26
52
53
54
55
56
57
58
Figure 22: Fluid Tube Components
Figure 22: Fluid Tube Components
Figure 22: Fluid Tube Components
Figure 22: Fluid Tube Components
Figure 22: Fluid Tube Components
VENT
VENT
BASE
BASE
VENT
VENT BASE
BASE
BASE
ORS)
ORS)
ORS)
ORS)
Description
Description
Description
Description
Description
4
Barrel
Fluid Tube Bracket
Fluid Spacer
Ferrule
Fluid Tube Connector Nut
Fluid Tube
Nut and Ferrule
Nut
Fluid Tube Bracket Fitting
5 0
5 0
5 0
5 0
5 0
Advertisement
Table of Contents
