Filters - Ransburg 75785 Service Manual

A C A C A C A C A C
I n I n I n I n I n
P o w e r P o w e r
P o w e r P o w e r P o w e r
S u p p l y S u p p l y S u p p l y S u p p l y S u p p l y
B o o t h B o o t h B o o t h B o o t h B o o t h
Figure 3: Typical REA Applicator Installation Figure 3: Typical REA Applicator Installation Figure 3: Typical REA Applicator Installation Figure 3: Typical REA Applicator Installation Figure 3: Typical REA Applicator Installation
W A R N I N G W A R N I N G
W A R N I N G W A R N I N G W A R N I N G
! ! ! ! !
The electrical discharge that is available
>
from the charging electrode must not
exceed 0.25 mJ of energy. To achieve this
limit, any flow of energy from the paint
supply through the paint line to the applica-
tor electrode must be prevented by ground-
ing the paint line at the applicator handle.
Verify that the applicator handle is actually
grounded before operating it! This is done
with a fully connected and operational sys-
tem, by placing one lead of an ohmmeter to
the handle and the other to the building
electrical ground (cold water pipe, building
structure, steel, etc.). This reading should
be essentially zero.
If a greater reading is obtained, check that
the control unit is grounded. See the con-
trol unit manual for grounding procedure.
W A R N I N G W A R N I N G
W A R N I N G W A R N I N G W A R N I N G
! ! ! ! !
When installing the AVIATOR Power
>
Generator, the air supply to the generator
must be interlocked with the booth exhaust
air and the conveyor system.
AH-94-04.7
REA-90 and 90L Spray Applicators - Installation
Air In Air In Air In Air In Air In
A i r A i r A i r
A i r A i r
R e g u l a t o r R e g u l a t o r R e g u l a t o r R e g u l a t o r R e g u l a t o r
P a i n t P a i n t
P a i n t P a i n t P a i n t
A p p l i c a t o r A p p l i c a t o r A p p l i c a t o r A p p l i c a t o r A p p l i c a t o r
S u p p l y S u p p l y S u p p l y S u p p l y S u p p l y
T a r g e t T a r g e t T a r g e t
T a r g e t T a r g e t
FIL FIL TERS TERS
FIL

FILTERS

FIL TERS TERS
1. Install an air filter assembly on the air inlet of the
control unit. Screw the fitting into the filter inlet.
The filter MUST be installed with the arrow pointing
in the direction of flow. Refer to the appropriate
filter assembly manual for installation instructions.
C A U T I O N C A U T I O N C A U T I O N
C A U T I O N C A U T I O N
! ! ! ! !
An air filter MUST be installed to permit
>
proper functioning of the air flow switch
inside the control unit.
2. ITW Ransburg recommends that a fluid filter be
installed at the output of the fluid supply (pressure
pot, pump, circulating system, etc.). It is the end
users responsibility to install a filter that meets
their system's requirements.
1 8 1 8 1 8 1 8 1 8