Ransburg 75785 Service Manual page 11

A R E A A R E A A R E A A R E A A R E A
Tells where hazards
may occur.
General Use and General Use and General Use and General Use and General Use and
Maintenance Maintenance Maintenance
Maintenance Maintenance
AH-94-04.7
H A Z A R D H A Z A R D
H A Z A R D H A Z A R D H A Z A R D
Tells what the hazard is.
Improper operation or maintenance
may create a hazard.
Personnel must be properly trained
in the use of this equipment.
REA-90 and 90L Spray Applicators - Safety
SAFEGUARDS SAFEGUARDS
SAFEGUARDS SAFEGUARDS SAFEGUARDS
Tells how to avoid the hazard.
Personnel must be given training in accordance with
the requirements of NFPA-33.
Instructions and safety precautions must be read and
understood prior to using this equipment.
Comply with appropriate local, state, and national
codes governing ventilation, fire protection, operation
maintenance, and housekeeping. Reference OSHA,
NFPA-33, and your insurance company requirements.
Always turn power to the power supply OFF, unplug
the electrical cord from its outlet, and remove the
front panel fuse, before opening the power supply
door. If necessary, lock the power supply out so that
it cannot be turned ON until the work is finished.
Whenever removing high voltage cables from
equipment, ground the contact end of the cable by
holding the cable such that the contact touches earth
ground for several seconds. Do not touch the contact
until it has been grounded. This will reduce the
possibility of residual charge causing electrical shock.
The High Voltage Multiplier Assembly contains energy
storage components that can cause serious shock
injury, and therefore is not field repairable. Warranty
will be voided if the High Voltage Multiplier seal is
broken. If the High Voltage Multiplier is defective
contact your authorized ITW Ransburg representative
for exchange or repair.
The High Voltage Multiplier and high voltage cable
contain significant capacitance that will store charge.
Allow approximately 10 seconds for this charge to
bleed off before opening the cabinet door or removing
the high voltage cable from the power supply or spray
applicator.
6 6 6 6 6