Side Panel Installation; Cut-Out - Sub-Zero Built-In Refrigeration Installation Manual

Side Panel Installation

Side Panels
IMPORTANT NOTE: Side panels will need to be installed
before the unit is placed in its final position.
When installing a built-in unit with a custom side panel, an
accessory kit (7003407) is required. Classic stainless steel
and white enamel side panels are available through your
Sub-Zero dealer. Refer to instructions included with the
side panel kit when installing these side panels. To obtain
local dealer information, visit the showroom locator
section of our website, subzero.com.
IMPORTANT NOTE: The use of side panels may change
the width of your rough opening.
24"
(610)
FRONT
OF SIDE
PANEL
ROUT TO 1
/ "
8 (3)
7
1 / "
8 (48)
1"
(25)
1
4 / "
4 (108)
5
ROUT TO
3
/ " (146)
16 (5)
(OVER-AND-UNDER
MODELS)
20
(521)
4"
(102)
OPTIONAL
TOE KICK

CUT-OUT

Custom side panel dimensions.
84"
(2134)
3
/ "
4
1
/ "
2
5
2 / "
8
(67)
CUSTOM SIDE PANEL INSTALLATION
The custom side panel will need to be a minimum of 24"
1
(610) deep and / " (13) thick. Refer to the custom side
2
panel dimensions illustration for additional specifications.
Routing will be necessary for the side panel to fit flush
against the side of the unit. Refer also to the routing detail
illustration.
IMPORTANT NOTE: The overall height on the side panel
will vary with the height of the grille being used. Make sure
you know your finished height before cutting any panels.
Install the brackets provided in the kit onto the side panel
in the locations shown in the illustration below. The front
brackets are meant to engage the mainframe and the back
brackets will wrap behind the unit when the panel is in
place. Screws are provided in the kit. If the provided
screws will not work for your installation, you will need to
provide the necessary screws to attach the brackets.
IMPORTANT NOTE: If you have a model BI-30U, BI-30UG,
BI-36U or BI-36UG, extra routing will be necessary to
avoid having the panel hit the refrigerator lower hinge
plate.
Place the panel at a 75° angle and engage the front
brackets into the mainframe. Swing the panel inward,
being sure that the front brackets engage the mainframe.
With the panel in position, attach the rear brackets to the
rear of the unit with the screws provided. Check to see
that the panel is secure. Refer to the illustration below.
1"
(25)
7
1 / "
8 (48)
1
/ "
8 (3)
1
/ "
2 (13)
MAIN SIDE PANEL
FRAME ROUTING
Side panel routing detail.
FRONT
BRACKET
SIDE PANEL
MAIN
REAR FRAME
BRACKET
Side panel attachment
(top view).
40