Sub-Zero Built-In Refrigeration Installation Manual page 33

Panel Installation
Flush Inset Panels
Install the handle hardware before inserting the panel. We
recommend larger D-style pulls. The use of small, one-
piece knobs is not recommended. If you use screws with
thick heads, you will need to countersink the screws into
the backer panel before sliding the assembly into place.
Slide the panel into the frame on the door. With the panel
in position, replace the frame end. Be sure the panel is
inserted completely into the channel for proper fit and
alignment.
To reinstall the trim molding on side-by-side models and
the upper door for over-and-under models, insert the top
of the trim molding into the grooves at the top of the door
and work downward, snapping the trim molding into the
clips on the frame.
For the drawer on over-and-under models, start at one
end and move towards the opposite end, snapping the
trim molding into the clips on the frame.
Grille Panel Assembly
Remove the inner grille panel assembly as described on
page 15. Remove the top two corner screws and pull
away the top frame. Slide the panel into position in the
grille frame. If you are using a grille panel
thinner, you will need to install a filler.
Reattach the top frame by reinstalling the two top corner
screws. Install the inner grille panel assembly onto the
unit, by reversing the grille removal procedure outlined on
page 15.
Refer to specifications for flush inset grille panels on
pages 34–35 and the illustrations on the previous page for
the exact sizing of all three panels.
Do not exceed the panel dimensions listed for the
appropriate flush inset grille panel you are speci-
fying. The flush inset decorative panel cannot be any
larger or it may restrict the air flow to the com-
pressor area and cause problems with the operation
of the Sub-Zero unit.
33
subzero.com
1
/ " (6) or
4