Panel Installation - Sub-Zero 500 series Planning And Installation Manual

Panel Installation

All Sub-Zero units easily
accommodate front, grille
as long as
and side panels
you follow the points listed
earlier
in the Integrating
Cabinetry section of this
guide. Installation is easy
following these steps.
If a metal or other thin mate-
rial is used, a filler must be
inserted behind your panel to
ensure a proper fit. All frames
are designed to accept up to
must be routed to the %"
perimeter dimension. There is
a 50 lb. weight limit for each
door panel.
Remove the door handle by
first removing the trim mold-
ing as shown in Figure 17
The molding easily comes off
piece of tape to
by using a
pull it away from the handle.
This removal will expose the
handle screws.
With a standard Phillips
screwdriver, remove door
handle on freezer and refrig-
erator door. The models 511
and 550 freezer door handle
is on the top of the door and
removed in the same manner.
Figure 17
Slide the appropriate panel
into the frame as illustrated
in Figure 18.
With the panel in position,
replace handle, screws and
trim molding. The molding
is replaced by bowing the
piece gently in the middle
and inserting the top and
bottom edges into the handle
channel first and then release
the middle.
Figure 18
Remove the trim molding in
an identical manner as illus-
trated in Figure 17.
Once the molding is
removed you can easily
remove the door screws on
both the refrigerator and
freezer doors by using a stan-
dard Phillips screwdriver.
Remove the handle trim
panels by sliding them out
of the door(s) as shown in
Figure 19. Complementary
colored handle trim panels
and glasswells are available
through your product
distributor.
Next, remove the ice and
water glasswell by removing
the mounting screw. Then
slide the glasswell up and pull
out as shown in Figure 19.
Figure 19