Side Panel Installation - Sub-Zero 542 Installation Instructions Manual

INSTALLATION
INSTRUCTIONS
r/d"
SIDE PANEL
INSTALLATION
If side panels are being
utilized, please check with
your installer for installation
methods or you may use one
of the side panel installation
methods shown in Figure 23.
Drill 3 holes equal distance
apart in vertical section of
aluminum frame and install
. pan head screws.
NOTE: Figure 23 is viewed from top edge of panel.
BACK OF SUB-ZERO UNI
FRAMEI
I 6 X 3/8 PAN HEAD SCREW 8 X
17/4
FLAT HEAD SCREW
1/41r SIDE PANEL MATERIAL
6 X 3/8 PAN HEAD SCREW 8 x 11/4FLATHEAD
I" 24_"
6 X 3/SPAN HEAD SCREW 8 X
17/4
FLAT HEAD SCREW
Anchor the side panel with
decorative headed screws
(as shown) or finishing nails
can be used. The screws/
nails must be obtained from
your local hardware supply
store.
NOTE: We do not
recommend the use of
adhesives.
Dimensions given for typical
wood side panel installation.
NOTE: If 1/4n(or less)panel
is used and inserted into
return channel extrusion
then a 241/4" size is
necessary for width. Sheet
must also be notched for
grille and other brackets
or screws that are in the
return channel. This is
only necessary on this
application.
ANCHORING
PRODUCT
Step 15
It is recommended after going
through the previous proce-
dures (front and side panel
installation, leveling and align-
ment and door adjustment)
proper anchoring of the unit to
the opening be done as this
will insure a proper installation.
1 1/8 ,,6 X 3/8PAN HEAD SCREW
8 x 11/4FI_AT HEAD S CREW
}-- 2 I/2" -_ 7/2
'1
SIDE PANEL MATERIAL
6 X 3/B PAN HEAD SCREW 8 X FLAT HEAD SCREW
METAL SIDE PANEL
Figure 23
Sub-Zero Anchoring Kit
#4-20-090-0 is available
through your Product
Distributor.
Part #4-20-090-0 Contents:
6 11/4" Sems
3 3h6 x 1 Chicago Screw
Posts
1 6-19-023-0 Loctite
Figures 24 and 25 are
examples.
NOTE: Product(s) must be
leveled and squared before
attempting this procedure.
Instructions for product
being tied together
(see Figure 24):
Figure 24
1) Drill three (3) 13/6411 h oles
through the middle trim of both
units.
I_CAUTION J
Do not drill through model
and serial number tag.