Panel Installation - Sub-Zero IT30RRH Installation Manual

PANEL INSTALLATION

Panel Installation
DOOR PANEL INSTALLATION
Typical panel dimensions are based on an 84"
height with 1 / " reveals. Template placement must be
(3)
8
adjusted for panels exceeding typical dimensions.
For tall models, the door panel should be installed first,
followed by the upper then lower drawer panel.
Place the panel face down on a protected work surface.
Position the template flush with the top and sides of the
panel. Verify the correct side of the template is being used,
then mark and drill holes. Refer to the illustration below.
For tall models, align the notch in the template with the
bottom of the door panel, then mark and drill holes. Refer to
the illustration below.
TOP OF DOOR PANEL
TOP OF
DOOR PANEL
84" APPLICATION
83 7/8" ACTUAL
USE TABS FOR HINGE
SIDE PANEL EDGE ON
DUAL INSTALLATION
Door panel template—top.
|
12 Sub-Zero Customer Care 800.222.7820
finished
(2134)
BOTTOM OF
DOOR PANEL
BOTTOM OF
DOOR PANEL
Door panel template—bottom
(tall models only).
Use the T-20 torx drive provided to partially insert a #8 x
screw into the second hole from the top on each side of the
panel. The screws should be approximately
of the panel and will support the weight of the panel during
installation.
Align the support screws on the back of the panel with the
slotted holes on both door mounting brackets. Opening the
door slightly may help with alignment. Once the panel is
supported by the screws, partially insert a #8 x
into the second hole from the bottom on each side of the
panel, but do not tighten.
CAUTION
As the reveal between cabinets and the unit decreases,
the potential exists for severe finger pinching if fingers
are placed in the opening when the door is closing.
BACK OF
DOOR PANEL
Door panel mounting.
1
/ "
2
3 / " proud
(4)
16
1
/ " screw
2