Sub-Zero Built-In Refrigeration Installation Manual page 29

Panel Installation
Glasswell—Dispenser Models
The dispenser area of models BI-42SD and BI-48SD has
been engineered to enable the use of the overlay or flush
inset panel application. Installing overlay or flush inset
panels for these models is the same procedure as for
other built-in models. The refrigerator door panel will need
to accommodate a cut-out for the glasswell bezel.
To remove the glasswell bezel for an overlay or flush inset
model BI-42SD or BI-48SD, the water grille and touch pad
must be removed. Lift the water grille up and out. Next,
remove the touch pad assembly by removing the center
plastic mandrel supports. Carefully tilt the touch pad out
and disconnect the wire harness (blue side up) from the
back side of the touch pad. Remove the bezel by
removing the four screws.
Insert the overlay or flush inset panel into the door trim.
Reverse the procedure to install the bezel, touch pad and
water grille. To install the plastic rivets, insert rivets
through the touch pad and into the control housing and
secure by pressing mandrels into the body of the rivets.
Refer to the illustrations below.
IMPORTANT NOTE: The total panel thickness (including
backer and spacer, if used) in the glasswell bezel area can
1
range from / " (6) to a maximum of 1
4
is thicker, provisions must be made to rout out a space to
accommodate the bezel surrounding the glasswell.
WATER
ICE
LOCK
INDICATOR
LIGHT
WATER
GRILLE
BEZEL
Glasswell—dispenser
models.
1
/ " (29). If the panel
8
Glasswell bezel removal.
Grille Panel Assembly
Remove the grille panel assembly as described on page
15. Remove the top two corner screws and pull away the
top frame. Slide the panel into position in the grille frame.
If you are using a grille panel
need to install a filler.
Reattach the top frame by reinstalling the two top corner
screws. Install the grille panel assembly onto the unit,
by reversing the grille removal procedure outlined on
page 15.
Refer to specifications for overlay grille panels on pages
30–31 and the illustrations on the previous page for the
exact sizing of all three panels.
Do not exceed the panel dimensions listed for the
appropriate overlay grille panel you are specifying.
The overlay decorative panel cannot be any larger or
it may restrict the air flow to the compressor area
and cause problems with the operation of the
Sub-Zero unit.
subzero.com
1
/ " (6) or thinner, you will
4
29