Printer Initialization - Wasp WPL205 User Manual

4.3 Printer Initialization

Printer initialization is used to clear DRAM and restore printer settings (with the exception of
ribbon sensitivity) to defaults.
Printer initialization is activated by the following procedures.
1. Turn off the power switch.
2. Press and hold the Feed button while turning the power back on.
3. Release the button when LED turns green after 5 amber blinks. (Any green will do during
the 5 blinks).
The LED color will be changed as following:
Amber red (5 blinks)
blinks) red/amber (5 blinks)
Printer configuration will be restored to defaults as outlined below after initialization.
Parameter
Speed
Density
Label Width
Label Height
Media Sensor Type
Gap Setting
Print Direction
Reference Point
Offset
Tear Mode
Peel off Mode
Cutter Mode
Serial Port Settings
Code Page
Country Code
Clear Flash Memory
Note：
Always do gap/black mark sensor calibration
amber (5 blinks)
solid green
Default setting
WPL205, 127 mm/sec (5 ips)
7
4.25" (108.0 mm)
2.5" (63.4 mm)
Gap sensor
0.12" (3.0 mm)
0
0,0 (upper left corner)
0
On
Off
Off
9600 bps, none parity,
8 data bits, 1 stop bit
850
001
No
after printer initialization.
15
green (5 blinks) green/amber (5