Gap/Black Mark Calibration, Self-Test, Dump Mode - Wasp WPL205 User Manual

4.2 Gap/Black Mark Calibration, Self-test, Dump Mode

While calibrating the gap/black mark sensor, the printer will measure the label length, print the
internal configuration (self-test) and then enter the dump mode.
Follow the steps as below.
1.Turn off the power switch.
2. Press and hold the Feed button while turning the power back on.
3. Release the button when LED becomes amber and blinking. (Any amber will do during the
5 blinks).
The LED color will be changed as follows:
Amber red (5 blinks)
blinks) red/amber (5 blinks)
Note:
Please select gap or black mark sensor using the GAP or BLINE command prior to
calibrating the sensor.
For more information about GAP and BLINE command, please refer to WPL
programming manual.
amber (5 blinks) green (5 blinks)
solid green
12
green/amber (5