Port Config; Static Multicast - TP-Link TL-SG3210 User Manual

8.2.4 Port Config

On this page you can configure MLD Snooping function with each single port.
Choose the menu Multicast→MLD Snooping→Port Config to load the following page.
The following entries are displayed on this screen:
Port Config

Select:
Port:
Filter:
Filter Mode:
Filter IDs:
Max Groups:
LAG:
Note:
If the Max Groups value is set less than the current value, some groups may be deleted to satisfy
the restriction.

8.2.5 Static Multicast

On this page you can configure static multicast groups. The multicast groups configured here are
not learned by MLD Snooping and independent of dynamic multicast groups and multicast filters.
The static multicast member ports won't age out.
Select the port you want to configure.
Displays the port number.
Choose to enable or disable filter function in this port.
Choose the filter action mode. You can accept or
refuse Report message with specific multicast groups
specify by the filter IDs.
Enter the filter IDs with this port. The filter IDs are
configured in Filer Config. The format is 1,4,12.
The max number of filter entries on each port is 15.
Enter the maximum groups which the port can join as
the member port. It ranges from 0 to 256.
Displays the LAG number.
132