Filter Config - TP-Link TL-SG3210 User Manual

Dynamic Router
Ports：
Note:
1. The MLD snooping function in a VLAN will take effect when global MLD Snooping function is
enabled in 8.2.1 Global Config
2. When the router port aging time or member port aging time is set for a VLAN, this value
overrides the value configured globally in

8.2.3 Filter Config

When the switch receives MLD report messages, it examines the multicast filtering ID and filter
mode configured on the access port to determine if the port can join the multicast group. If the port
can join the multicast group, the switch will add the port to the forward ports list of the multicast
group. Otherwise, the switch will drop the MLD report messages. In that way, you can control the
multicast groups that users can join in.
Choose the menu Multicast→MLD Snooping→Filter Config to load the following page.
The following entries are displayed on this screen:
Filter Config

Filter ID:
Start Multicast IP:
End Multicast IP:
Filter List

Select:
Filter ID:
Start Multicast IP:
End Multicast IP:
Note:
The max number of filter entries is 30.
Displays the dynamic router ports of this VLAN.
and the VLAN is created in
8.2.1 Global
Enter the Filter ID which identifies the filter.
Enter the start of the IP range.
Enter the end of the IP range.
Select the filter ID you want to change.
Displays the filter ID number.
Displays the start of the IP range.
Displays the end of the IP range.
131
Chapter 6 VLAN.
Config.