Notification - TP-Link TL-SG3210 User Manual

If SNMPv1 or SNMPv2c is employed, please take the following steps:

Step Operation
1 Enable SNMP function globally.
2 Create SNMP View.
3
Configure
access level
for the User.

13.2 Notification

With the Notification function enabled, the switch can initiatively report to the management station
about the important events that occur on the Views (e.g., the managed device is rebooted), which
allows the management station to monitor and process the events in time.
The notification information includes the following two types:
Trap ： Trap is the information that the managed device initiatively sends to the Network
management station without request.
Inform：Inform packet is sent to inform the management station and ask for the reply. The switch
will resend the inform request if it doesn't get the response from the management station during
the Timeout interval, and it will terminate resending the inform request if the resending times reach
the specified Retry times. The Inform type, employed on SNMPv2c and SNMPv3, has a higher
security than the Trap type.
On this page, you can configure the notification function of SNMP.
Create SNMP
Community
directly.
Create SNMP
Group and SNMP
User.
Description
Required. On the SNMP→SNMP Config→Global
Config page, enable SNMP function globally.
Required. On the SNMP→SNMP Config→SNMP
View page, create SNMP View of the management
agent. The default View Name is viewDefault and the
default OID is 1.
Required alternatively.
Create SNMP Community directly.

SNMP→SNMP
On the
Community page, create SNMP Community
based on SNMP v1 and SNMP v2c.
Create SNMP Group and SNMP User.

Similar to the configuration way based on
SNMPv3, you can create SNMP Group and
SNMP User of SNMP v1/v2c. The User name
can limit access to the SNMP agent from SNMP
network management station, functioning as a
community name. The users can manage the
device via the Read View, Write View and Notify
View defined in the SNMP Group.
213
Config→SNMP