Installing the Terminal
Follow the instructions below for the correct terminal installation in your vehicle.
Figure 2-1
shows the terminal installation on a 12-24V gasoline, diesel, or propane vehicle.
Figure 2-2
shows the installation on an electric vehicle operating up to 60V.
12-24V Gasoline, Diesel, or Propane Vehicles
Refer to
Table 2-1
for item descriptions. Refer to
•
Use of the filter box is recommended.
•
All power wiring must use the cable specified in item 1.
•
Fuse in positive rail = 10A max (item 11).
•
Fuse in negative rail = 10A max (item 11).
•
Fuse in switched positive = 2A max (when using the Filter Box).
•
Keep the path between the battery and the terminal as short as possible, and away
from any part of the ignition high tension system.
Installation of 12-24V gasoline, diesel or propane
vehicles
FUSE - 10A max
FUSE - 5A max
+
FUSE - 10A max
FUSE - 5A max
IGNITION SWITCH
Figure 2-1. Installation of 12-24V Gasoline, Diesel, or Propane Vehicles
FUSE - 2A max
EARTH POINT (AS
CLOSE AS POSSIBLE
TO THE IGNITION
SWITCH)
Figure 2-1
for installation.
12-24V FILTER BOX
VRC 89XX
VRC7900
Installing the Terminal
2-5