Table of Contents
Advertisement
$ Only maintenance personnel or
a trained Telxon service technician
should install the PTC-870IM.
You must provide the hardware to
perform this procedure.
The PTC should be located so that it
is not resting against any structure
(except the supplied bracket).
Make sure excessive pressure will
not be placed on the cables and the
antenna is away from any metallic
obstructions.
If your PTC-870IM is replacing a PTC-
860IM, remove the old bracket from
the vehicle and line up the circular
holes in the new bracket with the
existing holes in the vehicle. Other-
wise, fasten the mounting bracket to
the vehicle through its slotted holes.
Installing the PTC-870IM
The following procedures describe how to mount a
PTC-870IM onto a warehouse vehicle and connect it
to vehicle power. Follow the procedures carefully to
avoid damaging the PTC and/or the vehicle.
Installing the mounting bracket
Follow the instructions below to attach the mounting
bracket to a warehouse vehicle.
1. Gather the hardware and tools needed to bolt the
mounting bracket onto the vehicle.
2. Select a location on the vehicle for the mounting
bracket. The location should provide the driver
with a good view of the PTC's display and should
not interfere with the driver's vision or the
vehicle's operation.
3. Before making the final decision, attach an
antenna, the correct power cable, a laser scanner,
and a serial cable to the PTC-870IM; hold the
PTC in the desired location; and check for
clearance of these items.
4. Fasten the PTC-870IM's mounting bracket
securely to the frame or housing of the vehicle.
A
Appendix
47
Advertisement
Table of Contents
