Suzuki GSF650S Service Manual page 97

NOTE:
Pull 1 the crankshaft to the left so that there is no clearance on
the right-side thrust bearing.
( Crankshaft thrust clearance
Standard: 0.04 – 0.09 mm
If the thrust clearance exceeds the standard range, adjust the
thrust clearance as follows:
• Remove the right-side thrust bearing and measure its thick-
ness using the micrometer. If the thickness of the right-side
thrust bearing is below standard, replace it with a new bearing
and measure the thrust clearance again, as described above.
( Right-side thrust bearing thickness
Standard: 2.425 – 2.450 mm
• If the right-side thrust bearing is within the standard range,
reinsert the right-side thrust bearing and remove the left-side
thrust bearing.
• With the left-side thrust bearing removed, measure the clear-
ance using the thickness gauge as shown. Then, select a left-
side thrust bearing from the selection table below.
Left-side thrust bearing selection table
Clearance before
inserting the left-side
thrust bearing
2.415 – 2.440 mm
2.440 – 2.465 mm
2.465 – 2.490 mm
2.490 – 2.515 mm
2.515 – 2.540 mm
2.540 – 2.565 mm
Color 1
(Part No.)
Red
(12228-43411)
Black
(12228-43412)
Blue
(12228-43413)
Green
(12228-43414)
Yellow
(12228-43415)
White
(12228-43416)
Thrust bearing thick-
ness
2.350 – 2.375 mm
2.375 – 2.400 mm
2.400 – 2.425 mm
2.425 – 2.450 mm
2.450 – 2.475 mm
2.475 – 2.500 mm
ENGINE 3-61
Thrust clearance
0.04 – 0.09 mm