Suzuki GSF650S Service Manual page 101

• Install the bearing pins C and C-rings D into the upper crank-
case.
• Install the countershaft assembly E and driveshaft assembly
F into the upper crankcase.
NOTE:
* Be sure to install the bearing dowel pins G in their respective
positions.
* Install the countershaft end cap in the proper position H.
* Make sure that the countershaft assembly turns freely while
holding the driveshaft assembly. If it does not turn freely, turn
the gearshift cam to the neutral position.
NOTE:
Before installing the crankshaft journal bearings, make sure that
the oil jets I in the upper crankcase are not clogged.
I Oil jet (4 pcs) ..........................In the upper crankcase
• When installing the crankshaft journal bearings into the upper
and lower crankcases, be sure to install the tab J first, and
then press in the opposite side of the bearing.
$
Do not touch the bearing surfaces with your hands.
Grasp the bearings by their edges.
• Install the cam chain tensioner K and the two dampers L
properly.
NOTE:
Be sure to face the arrow mark on the damper towards the front
and rear, not towards the left and right.
ENGINE 3-65