Suzuki GSF650S Service Manual page 110

3-74 ENGINE
• Apply a light coat of SUZUKI BOND to the starter clutch cover
gasket mating surface C as shown.
, 99000-31140: SUZUKI BOND "1207B"
• Install the dowel pin, a new gasket and the starter clutch
cover, and tighten the cover bolts securely.
NOTE:
Install the gasket washer to the starter clutch cover bolt A as
shown.
$
Use a new gasket washer to prevent oil leakage.
SIGNAL GENERATOR
• Install the oil pressure switch, apply the SUZUKI BOND to its
thread and tighten it to the specified torque.
, 99000-31140: SUZUKI BOND "1207B"
# Oil pressure switch: 14 N·m (1.4 kgf-m)
• Install the signal generator stator (along with the pickup coil)
1.
• Be sure to fit the slot B on the back surface of the signal gen-
erator rotor over the locating pin 2 on the end of crankshaft.
NOTE:
The SUZUKI BOND should be applied to the groove of the sig-
nal generator lead wire grommet C.
, 99000-31140: SUZUKI BOND "1207B"
• Hold the nut and tighten the signal generator rotor bolt to the
specified torque.
# Signal generator rotor bolt: 26 N·m (2.6 kgf-m)
• Connect the oil pressure switch lead wire.