5-62
CHASSIS
PISTON SEAL
• Install the piston seals as shown in the illustration.
• Install the pistons to the caliper.
1 Dust seal
2 Piston seal
3 Caliper
NOTE:
Before installing pads, apply SUZUKI PBC GREASE or equiva-
lent grease to the shim contact surface of caliper pistons.
99000-25110: SUZUKI PBC GREASE
• Tighten the brake caliper mounting bolts 4 and housing bolts
5 to the specified torque.
• After setting the brake hose union to the stopper, tighten the
union bolt 6 to the specified torque.
# Brake caliper mounting bolt 4: 26 N·m (2.6 kgf-m)
Brake caliper housing bolt 5: 37 N·m (3.7 kgf-m)
Brake hose union bolt 6: 23 N·m (2.3 kgf-m)
NOTE:
Before remounting the brake caliper, push the brake caliper pis-
tons all the way into the caliper.
$
* The seal washers should be replaced with the new
ones to prevent fluid leakage.
* Bleed air from the system after reassembling the cal-
iper. (!2-17)
)
After remounting the brake calipers, pump the brake
pedal until the pistons push the pads correctly.