Default Settings In The Control Computer - Danfoss DHP-H User Manual

10

Default settings in the control computer

The first column in the table below shows the parameters that can be adjusted by the User.
The second column shows settings made at the factory, and the third column the settings
made by the installation contractor in connection with installation of the heat pump.
Make sure that the installation contractor enters any settings made during installation that
are particular to your heat pump. This will make it easier for you when you make your own
adjustments.
Setting
ROOM
OPERATION
CURVE
MIN
MAX
CURVE 
CURVE 0
CURVE -
HEATSTOP
REDUCTION
Danfoss – 
Factory setting
20°C
AUTO
0°C
10°C
°C
0°C
0°C
0°C
1°C
2°C
VUBMA102
Customer specific settings