Control Computer - Danfoss DHP-H User Manual

3

Control computer

A control computer is used to automatically calculate the heat demand in the house where
the heat pump is installed and to ensure that the correct amount of heat is produced and
emitted where necessary. There are many different values (parameters) that must be referred
to during the calculation of the heat demand. Use the control computer to set and change
certain values that have to be adapted according to the house demand.
The display window, keypad and an indicator are on the front of the control computer. It con-
sists of a simple menu system that is used to navigate the desired settings and values.
ROOM 20°C
NO DEMAND HEAT
OPERAT. AUTO
Use the four control buttons on the keypad to navigate the menus and increase or reduce the
set values:
• An up button with a plus sign
• A down button with a minus sign
• A right button with a right arrow
• A left button with a left arrow
The display always shows the set ROOM value and the status of the heat pump.
The main menu, INFORMATION, is opened by pressing the left or right buttons. From
INFORMATION one of the four sub-menus can be opened:
OPERAT.; HEATCURVE; TEMPERATURE and OPERAT. TIME.
Danfoss – 18
Figure 15: Display, control buttons and indicator for the heat pump .
The symbols in the display are
only examples. Certain sym-
bols cannot be displayed at
the same time.
VUBMA102