Danfoss DHP-H User Manual page 10

CurVe
The control computer shows the value for CURVE by means of a graph in the display. You can
set the heat curve by adjusting the CURVE value. The CURVE value indicated which supply
temperature the heating system is to have at an outdoor temperature of 0°C.
Supply temperature
At outdoor temperatures colder than 0°C, supply water hotter than 0°C is sent out to the
heating system and at outdoor temperatures greater than 0°C, supply water cooler than 0°C
is sent out.
Supply temperature
Figure 4: Increasing or reducing the CurVe changes the slope of the curve
If you increase the CURVE value, the heat curve will become steeper and when you reduce it,
it will become flatter.
Danfoss – 10
Value for CURVE is 0...
Figure 3: Graph showing the set value 40 for CurVe .
VUBMA102
Maximum supply tem-
perature
Outdoor temperature
...at zero degrees
Maximum supply tem-
perature
Outdoor temperature