Hole Punching Mode - Toshiba e-studio 45 Operator's Manual

5. HOLE PUNCHING MODE

With the optional punching unit attached to the optional finisher (MJ-1012 or MJ-1013 only), you can
1
have your copies punched with holes.
* The thickness of paper should be in the range of 17 lb. Bond to 110 lb. Index. Special paper such as
OHP film is excluded.
2
1
Set the originals.
3
2 Press the key on the basic screen as shown on the
right (shaded).
4
5
3
Press the HOLE PUNCH key.
6
• If the key for the desired function is not shown, press the
Next key to switch the screen.
7
Select other copy modes as required.
4 Press the
8
Tip
Number of punch holes and available paper sizes:
Since the number of punch holes and the distance between
the holes vary depending on countries, purchase a punching
9
unit that meets your requirements. (For details, consult your
service technician.)
10
Japan and most of
Europe (MJ-6001E)
11
North America
(MJ-6001N)
France
(MJ-6001F)
12
Sweden
(MJ-6001S)
6-8
SELECTING FINISHING MODES (USING THE OPTIONAL FINISHERS)
Page 2-4
START key.
Number of punch holes and hole diameter
2 holes
(6.5 mm dia.)
2/3 holes switchable
(8.0 mm or 0.31" dia.)
4 holes
(6.5 mm dia.; 80 mm pitch)
4 holes
(6.5 mm dia; 70, 21 mm pitch)
Available paper sizes
A3, B4, A4, A4-R, B5, B5-R,
FOLIO
2 holes: LG, LT-R, COMP
3 holes: LD, LT
A3, A4
A3, B4, A4, A4-R, B5, B5-R,
FOLIO