Safety Precautions - Harsco Industrial C1500H Installation & Owner's Manual

The safety labels shown above are affixed to your boiler. Although the labels are of high quality, they may become
dislodged or unreadable over time. Contact Harsco Industrial, Patterson-Kelley at 570.476.7261 or toll-free at
877.728.5351 for replacement labels.
2.5 S P
AFETY RECAUTIONS
Provide a suitable location for the boiler, away from normal personnel traffic, with adequate working space, adequate
clearances, proper ventilation and lighting, with a structure sufficiently strong and rigid to support the weight of the
boiler, all piping, and accessories.
2.5.1 Electrical Hazards
2.5.2 Burn, Fire, and Explosion Hazards
General Warning
WARNING
!
Improper use may
result in fire or injury.
Read instructions/safety
manual before installing,
operating or servicing boiler.
c
1998 HCS, Inc. 800-748-0241 Reorder No. 6020-V2WHPK

Burn hazard! Hot fluids. Use caution when servicing or draining boiler.
Hot Surface

Shock hazard! Properly lockout/tag out the electrical service and all other
energy sources before working on or near the boiler.

Shock hazard! Do not spray water directly on this boiler or on any electrical
components.

Electrical hazard! Do not alter wiring connections.

Burn, fire, and explosion hazards! Installation must be in strict conformance to all
applicable codes and standards including NFPA 54, ANSI Z223.1 and CAN/CSA
B.149. Install all required vent lines for gas devices. Refer to Section 3.6.

Hazard from incorrect fuels! Possible fire, explosion, overheating, and damage. Do
not use any fuels except the design fuels for the unit.

Over fire hazards! High pressure in gas supply could result in over firing of this or
other devices supplied from the same source.

Fire and explosion hazards! Close the main gas shutoff before servicing boiler.

Fire and explosion hazards! Do not store or use gasoline or other flammable vapors
or liquids in the vicinity of this or any other gas fired appliance.

Burn hazard! Possible hot surfaces. Do not touch gas vent during firing operation.
Use only factory recommended vent components.

Burn hazard! Pipes, vents, and boiler components could be hot. Do not touch piping
or stack surfaces during operation or immediately after shutdown of the boiler.
WARNING
!
Improper use may
result in fire or injury.
Read instructions/safety
manual before installing,
operating or servicing boiler.
c
1998 HCS, Inc. 800-748-0241
9
®
MACH Gas Fired Boiler
Reorder No. 6020-V2WHPK